Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A353/A353M-17(2022)
Standard Specification for Pressure Vessel Plates, Alloy Steel, Double-Normalized and Tempered 9 % Nickel
NORMA vydaná dňa 1.9.2022
Informácie o norme:
Označenie normy: ASTM A353/A353M-17(2022)
Dátum vydania normy: 1.9.2022
Kód tovaru: NS-1085748
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM A353/A353M-17(2022) :
This guide covers standard specification for nickel steel plates, double-normalized and tempered, intended particularly for welded pressure vessels for cryogenic service. The steel shall be killed and shall conform to the fine austenitic grain size requirement. All plates shall undergo heat and product analysis and shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, and nickel. Tensile properties of the steel plate shall meet the specified values for tensile strength, yield strength, and elongation. The material shall undergo mechanical tests such as tension test and impact test.
Keywords:
alloy steel, alloy steel plate, pressure containing parts, pressure vessel steels, steel plates, steel plates for pressure vessel applications,, ICS Number Code 77.140.30 (Steels for pressure purposes)
Doplňujúce informácie
| 1. Scope | ||||||||
|
1.1?This specification1.2?Plates produced under this specification are subject to impact testing at ?320 ?F [?195 ?C] or at such other temperatures as are agreed upon. 1.3?The maximum thickness of plates is limited only by the capacity of the material to meet the specific mechanical property requirements. 1.4?This material is susceptible to magnetization. Use of magnets in handling after heat treatment should be avoided if residual magnetism would be detrimental to subsequent fabrication or service. 1.5?The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
| 2. Referenced Documents | ||||||||
|
Doporučujeme:
