Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A134/A134M-19
Standard Specification for Pipe, Steel, Electric-Fusion (Arc)-Welded (Sizes NPS 16 and Over)
NORMA vydaná dňa 1.11.2019
Informácie o norme:
Označenie normy: ASTM A134/A134M-19
Dátum vydania normy: 1.11.2019
Kód tovaru: NS-976674
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM A134/A134M-19 :
This specification covers electric-fusion (arc)-welded straight seam or spiral seam steel pipes with diameters NPS 16 and larger. The materials for these pipes as well as the welding procedure shall conform to other ASTM standards listed herein. This standard also contains requirements for the permissible weight and dimension variations and pipe lengths.
Keywords:
ICS Number Code 23.040.10 (Iron and steel pipes)
Doplňujúce informácie
| 1. Scope |
|
1.1 This specification covers electric-fusion (arc)-welded straight seam or spiral seam steel pipe NPS 16 and over in diameter (inside or outside as specified by purchaser), with wall thicknesses up to 3/4 in. [19 mm], inclusive. Pipe having other dimensions may be furnished provided such pipe complies with all other requirements of this specification. The pipe is available in various grades based on the ASTM specification ordered (Section 4). Note 1: Acceptability for many services may be controlled by
codes or standards such as those published by the American National
Standards Institute and American Society of Mechanical
Engineers.
Note 2: For testing methods not specifically covered in this
specification, reference can be made to Test Methods and
Definitions A370, with
particular reference to Annex A2 on Steel Tubular
Products.
Note 3: A comprehensive listing of standardized pipe
dimensions is contained in ANSI B 36.10.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order. In this specification hard or rationalized conversions apply to diameter, lengths, and tensile properties. Soft conversion applies to other SI measurements. Note 4: The dimensionless designator NPS (nominal pipe size)
has been substituted in this standard for such traditional terms as
“nominal diameter,” “size,” and “nominal size.”
1.3 The following caveat pertains specifically to Section 5 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Doporučujeme:
