Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A1044/A1044M-22a
Standard Specification for Steel Stud Assemblies for Shear Reinforcement of Concrete (Includes all amendments and changes 11/18/2022).
NORMA vydaná dňa 1.11.2022
Informácie o norme:
Označenie normy: ASTM A1044/A1044M-22a
Dátum vydania normy: 1.11.2022
Kód tovaru: NS-1089338
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM A1044/A1044M-22a :
Keywords:
base rail, concrete reinforcement, headed studs, shear reinforcement, steel, stud assemblies,, ICS Number Code 91.080.40 (Concrete structures)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||
|
1.1?This specification covers steel stud assemblies for shear reinforcement of concrete. Stud assemblies consist of either single-headed studs (Type 1) attached to a structural steel base rail by structural welding or stud welding, or double-headed studs (Type 2) mechanically crimped into a non-structural steel shape or attached to a steel plate by spot welding or tack welding. These stud assemblies are not intended for use as shear connectors in steel-concrete composite construction. Note 1:?The configuration of the studs for stud assemblies is
much different than the configuration of the headed-type studs
prescribed in Clause 9, Figure 9.1 of AWS D1.1/D1.1M. Ratios of the
cross-sectional areas of the head-to-shank of the AWS D1.1/D1.1M
studs range from about 2.5 to 4. In contrast, this specification
requires the area of the head of the studs for stud assemblies to
be at least 10 times the area of the shank. Thus, the standard
headed-type studs in Clause 9, Figure 9.1 of AWS D1.1/D1.1M do not
conform to the requirements of this specification for use as stud
assemblies for shear reinforcement.
1.2?This specification is applicable for orders in either inch-pound units or in SI units. 1.3?The values stated either in inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this specification. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
