Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Composite Corrugated Steel Pipe for Sewers and Drains (Withdrawn 2015)
Automaticky preložený názov:
Štandardné špecifikácie pre Composite vlnitej oceľové rúrky pre kanalizácie a kanalizáciu
NORMA vydaná dňa 1.11.2009
Označenie normy: ASTM A1042/A1042M-04(2009)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.11.2009
Kód tovaru: NS-1186
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
composite corrugated steel pipe, corrugated steel pipe, drainage pipe, sewer pipe, Corrugated steel sewer/drain pipe, Drains, Sewers, ICS Number Code 93.030 (External sewerage systems)
1. Scope | ||||||||||||||||||||||||||||||||||||||
1.1 This specification covers composite corrugated steel pipe, intended for uses such as storm water drainage, sanitary sewers, underdrains, construction of culverts, and similar uses. The composite material used in fabrication of the pipe consists of a three-layer polymer protective coating on both sides of a steel sheet core. The three layers consist of an inner layer of fusion-bonded epoxy on the steel surface, an intermediate layer of polyethylene adhesive, and an outer layer of high-density polyethylene. 1.2 The three-layer polymer coating protects the base metal against corrosion or abrasion, or both. Severe environments are likely to cause corrosion problems to accessory items such as coupling band hardware unless supplemental protection is provided. Additional protection for composite steel pipe is available by use of coatings applied after fabrication of the pipe as described in Specification A849. 1.3 This specification does not include requirements for bedding, backfill, or the relationship between earth cover load and sheet thickness of the pipe. Experience with drainage products has shown that successful performance depends upon the proper selection of corrugation profile, sheet thickness, type of bedding and backfill, controlled manufacture in the plant, and care in installation. The installation procedure is described in Practice A798/A798M. 1.4 This specification is applicable to orders in either inch-pound units as A1042, or in SI units as A1042M. Inch-pound units and SI units are not necessarily equivalent. SI units are shown in brackets in the text for clarity, but they are the applicable values when the material is ordered to A1042M. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. |
||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-09-02 (Počet položiek: 2 345 509)
© Copyright 2024 NORMSERVIS s.r.o.