Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A1011/A1011M-15
Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength
Automaticky preložený názov:
Standard Specification pre Steel, plechy a pásy valcované za tepla, Uhlík, Structural, vysokopevnostné nízkolegovanej, vysokopevnostné nízkolegovanej so zlepšenou tvárniteľnosti a Ultra-High Strength
NORMA vydaná dňa 1.12.2015
Informácie o norme:
Označenie normy: ASTM A1011/A1011M-15
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2015
Kód tovaru: NS-625370
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM A1011/A1011M-15 :
Keywords:
carbon steel sheet, carbon steel strip, commercial steel, drawing steel, special forming steel, high strength-low alloy steel, high strength-low alloy steel with improved formability, hot-rolled steel sheet, hot-rolled steel strip, steel sheet, steel strip, structural steel, ultra-high strength steel,, ICS Number Code 77.140.20 (Steels of high quality)
Doplňujúce informácie
| 1. Scope | ||||||||||||||
|
1.1 This specification covers hot-rolled, carbon, structural, high-strength low-alloy, high-strength low-alloy with improved formability, and ultra-high strength steel sheet and strip, in coils and cut lengths. 1.2 Hot rolled steel sheet and strip is available in the designations as listed in 4.1. 1.3 This specification is not applicable to the steel covered by Specification A635/A635M. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
Doporučujeme:
