Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A1011/A1011M-09a
Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength (Includes all amendments And changes 12/31/2010).
Automaticky preložený názov:
Štandardné špecifikácie pre oceľ, plechy a pásy , valcované za tepla , Carbon , štrukturálne , High - pevnosť Low - Alloy , High - pevnosť Low - Alloy so zlepšenou tvárniteľnosti , a Ultra - High Pevnosť
NORMA vydaná dňa 1.5.2009
Informácie o norme:
Označenie normy: ASTM A1011/A1011M-09a
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2009
Kód tovaru: NS-1039
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM A1011/A1011M-09a :
Keywords:
carbon steel sheet, carbon steel strip, commercial steel, drawing steel, high strength-low alloy steel, high strength-low alloy steel with improved formability, hot-rolled steel sheet, hot-rolled steel strip, steel sheet, steel strip, structural steel, ultra-high strength steel, Carbon steel sheet/strip--specifications, Commercial steel (CS) sheet/strip--specifications, Drawing steel (DS) sheet/strip--specifications, Hot-rolled steel sheet/strip--specifications
Doplňujúce informácie
| 1. Scope | ||||||||||||||
|
1.1 This specification covers hot-rolled, carbon, structural, high-strength low-alloy, high-strength low-alloy with improved formability, and ultra-high strength steel sheet and strip, in coils and cut lengths. 1.2 Hot rolled steel sheet and strip is available in the designations as listed in 4.1. 1.3 This specification is not applicable to the steel covered by Specification A 635/A 635M. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
Doporučujeme:
