Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Determination of Gold in Cyanide Solutions
Automaticky preložený názov:
Štandardné testovacie metódy pre stanovenie zlata v kyanidu Solutions
NORMA vydaná dňa 1.4.2015
Označenie normy: ASTM E1600-15
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2015
Kód tovaru: NS-588599
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
cyanide solutions, flame atomic absorption spectrometry, gold concentration, inductively coupled plasma mass spectrometry,, ICS Number Code 73.060.99 (Other metalliferrous minerals)
Significance and Use | ||||||||||||||||||||||||||
4.1 In primary metallurgical processes for gold bearing ores, gold is extracted with an alkaline cyanide solution. Metallurgical accounting, process control, and ore evaluation procedures depend on accurate, precise, and prompt measurements of the gold concentrations. 4.2 These test methods are comparative referee methods for compliance with compositional specifications for metal concentration or to monitor processes. It is assumed that all who use these methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory under appropriate quality control practices such as those described in Guide E882, and that proper waste disposal procedures will be followed. |
||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||
1.1 These test methods cover the determination of gold in ore processing cyanide solutions within the following ranges:
Note 1: The lower limit for the Inductively Coupled Plasma
Mass Spectrometry Method, 0.001 µg/mL, was set following the
guidance of Practice E1601.
The reproducibility Index, R, was calculated using the total
standard deviation for the lowest concentration Youden pair
solution.
1.1.1 These test methods may also be applied to cyanide leach solutions from metallurgical evaluation procedures. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 The test methods appear in the following order:
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in 11.1, 11.1.1, 11.5, and 12.2. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-04-19 (Počet položiek: 2 860 954)
© Copyright 2024 NORMSERVIS s.r.o.