Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determining the Size of Iridium-192 Industrial Radiographic Sources
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie veľkosti Iridium-192 priemyselných rádionuklidov
NORMA vydaná dňa 1.10.2014
Označenie normy: ASTM E1114-09(2014)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2014
Kód tovaru: NS-40482
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
cylinder(s), Iridium 192, radiographic source, reference sample, source size, sphere, ICS Number Code 19.100 (Non-destructive testing)
Significance and Use | ||||||||||||
4.1 One of the factors affecting the quality of a radiographic image is geometric unsharpness. The degree of geometric unsharpness is dependent upon the size of the source, the distance between the source and the object to be radiographed, and the distance between the object to be radiographed and the film or digital detector. This test method allows the user to determine the size of the source and to use this result to establish source to object and object to film or detector distances appropriate for maintaining the desired degree of geometric unsharpness. Note 1: The European standard CEN EN 12579 describes a
simplified procedure for measurement of source sizes of Ir-192,
Co-60 and Se-75. The resulting source size of Ir-192 is comparable
to the results obtained by this test method.
|
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers the determination of the size of an Iridium-192 radiographic source. The determination is based upon measurement of the image of the Iridium metal source in a projection radiograph of the source assembly and comparison to the measurement of the image of a reference sample in the same radiograph. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historická
1.7.2009
Historická
15.6.2012
Historická
1.11.2012
Historická
15.6.2012
Historická
1.6.2010
Historická
1.11.2012
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-04-23 (Počet položiek: 2 895 375)
© Copyright 2024 NORMSERVIS s.r.o.