Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D8030/D8030M-19
Standard Practice for Sample Preparation for GCCM
NORMA vydaná dňa 1.1.2019
Informácie o norme:
Označenie normy: ASTM D8030/D8030M-19
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2019
Kód tovaru: NS-935460
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D8030/D8030M-19 :
Keywords:
GCCM, geosynthetic cementitious composite mat, index test, preparation, sampling,, ICS Number Code 59.080.70 (Geotextiles),91.100.99 (Other construction materials)
Doplňujúce informácie
| Significance and Use | ||||||
|
5.1 This practice is intended to create specimens of GCCM products appropriate for testing for the determination of index properties. Cured (hardened) samples are not necessarily intended to represent a field application of GCCM products, but would be representative of the correct amount of water applied to a known style of product and provide a basis for consistent and repeatable index property testing. |
||||||
| 1. Scope | ||||||
|
1.1 This standard practice specifies a set of instructions for preparing samples of geosynthetic cementitious composite mat (GCCM) for index property testing. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026. 1.3.1 For purposes of comparing measured or calculated value(s) with specified limits, the measured or calculated value(s) shall be rounded to the nearest decimal or significant digits in the specified limits. 1.3.2 The procedures used to specify how data are collected/recorded or calculated in this practice are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be measured. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce the significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this practice to consider significant digits used in the analytical methods for engineering design. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
