Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Testing of Factory Thermo-Fusion Seams for Fabricated Geomembrane Panels
Automaticky preložený názov:
Štandardný postup skúšania Factory Thermo-Fusion švy sú vyrobené geomembrány panely
NORMA vydaná dňa 1.1.2015
Označenie normy: ASTM D7982-15
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2015
Kód tovaru: NS-39315
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
fabricated, fabricated panel, factory seam, geomembrane, MQC, seam, welding,, ICS Number Code 59.080.70 (Geotextiles)
Significance and Use | ||||||||||||||
4.1 This practice is intended to aid fabricators, suppliers, purchasers, and users of fabricated panels in the testing requirements for factory created seams during fabrication of geomembrane panels. 4.2 Factory seaming of geomembranes has advantages over field seaming including less temperature variation, no wind, less contamination (soil and water) concerns, a consistent work surface for welding and options for factory equipment that may not be robust enough for the field environment. This results in factory welds more consistent than field seams and allows for a lesser frequency of testing than for field seams. 4.3 This guide is not intended to replace project-specific seaming and testing requirements or quality assurance programs. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This practice provides manufacturing quality control guidance for the factory seaming of fabricated geomembrane panels. This practice is not to be considered as all-encompassing since there are a large number of geomembrane types, weld types and fabrication processes that cannot be anticipated and covered in this document. 1.2 This practice is written for factory fabricated geomembrane panels only and does not apply to field fabrication on-site. 1.3 This practice does not cover joining of materials during the primary geomembrane manufacturing process such as the vulcanized overlaps found in EPDM sheet. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Posledná aktualizácia: 2024-04-25 (Počet položiek: 2 896 007)
© Copyright 2024 NORMSERVIS s.r.o.