Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Fully-Formulated Glycerin Base Engine Coolant for Heavy-Duty Engines
Automaticky preložený názov:
Štandard Specification pre plne formulovaných Glycerín Základné chladiacej kvapaliny pre motory veľkého výkonu
NORMA vydaná dňa 1.6.2012
Označenie normy: ASTM D7715-12
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2012
Kód tovaru: NS-39002
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Chladicí prostředky. Mrazicí prostředky. Mrazuvzdorné prostředky
Keywords:
cavitation, fully-formulated heavy-duty engine coolant, glycerin, supplemental coolant additive maintenance dose, ICS Number Code 71.100.45 (Refrigerants and antifreezes)
1. Scope | ||||||||||||||||||||||
1.1 This specification covers the requirements for fully-formulated glycerin base coolants for cooling systems of heavy-duty engines. When concentrates are used at 40 to 60 % glycerin concentration by volume in water of suitable quality (see Appendix X1), or when prediluted glycerin base engine coolants (50 volume % min) are used without further dilution, they will function effectively during both winter and summer to provide protection against corrosion, cavitation, freezing, and boiling. 1.2 This specification is intended to cover the requirements for engine coolants prepared from virgin glycerin. Note 1—This specification is based on the knowledge of the performance of engine coolants prepared from new or virgin ingredients that comply with Specification D7714. 1.3 The coolants governed by this specification are categorized as follows:
1.4 Coolant concentrates meeting this specification do not require addition of supplemental coolant additive (SCA) until the first maintenance interval when a maintenance dose of SCA is required to continue protection in certain heavy duty engine cooling systems, particularly those of the wet cylinder liner-in-block design. The SCA additions are defined by and are the primary responsibility of the engine manufacturer or vehicle manufacturer. If they provide no instructions, follow the SCA supplier's instructions. 1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Historická
1.5.2013
Historická
1.4.2014
Historická
1.10.2012
Historická
1.10.2011
Historická
1.4.2012
Historická
1.11.2009
Posledná aktualizácia: 2024-10-31 (Počet položiek: 2 208 647)
© Copyright 2024 NORMSERVIS s.r.o.