Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practices for Sampling Ferroalloys and Steel Additives for Determination of Chemical Composition
Automaticky preložený názov:
Štandardné postupy odberu vzoriek zliatin železa a ocele prísady pre stanovenie chemického zloženia
NORMA vydaná dňa 15.12.2015
Označenie normy: ASTM E32-15
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.12.2015
Kód tovaru: NS-632727
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
chemical composition, ferroalloys, sampling, steel additives ,, ICS Number Code 77.040.30 (Chemical analysis of metals),77.100 (Ferroalloys)
Significance and Use | ||||||
4.1 These practices for the sampling of ferroalloys and steel additives are primarily intended to test such materials for compliance with compositional specifications. It is assumed that all who use these methods will be trained samplers capable of performing common sampling procedures skillfully and safely. |
||||||
1. Scope | ||||||
1.1 These practices include procedures for the sampling of the various ferroalloys and steel additives, either before or after shipment from the plants of the manufacturers. They are designed to give results representative of each lot that will be comparable with the manufacturer's guaranteed analysis for the same lot. For check analysis, the purchaser may use any sampling procedure he desires, but the analytical results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these methods. 1.2 In sampling ferroalloys and steel additives, serious errors often occur from contamination of the samples by iron from the sampling appliances. Therefore, special precautions should be observed to avoid this source of error. Metallic iron may be removed with a magnet from nonmagnetic alloys; its estimation in other alloys requires special analytical procedures (Note 1). To avoid this error, parts of crushers and pulverizing equipment contacting the samples shall be of steel or other material showing a high resistance to abrasion of the type involved. Note 1: Metallic iron in ferrochromium and ferrosilicon may be
determined as follows: Transfer 5 g of the sample of alloy to a
150-mL beaker, add 25 mL of HNO3 (1 + 3), cover, boil 5 min,
filter into a 250-mL beaker, and wash with hot water. Add
NH1.3 The values stated in SI units are to
be regarded as the standard. The inch-pound values in parenthesis
are given for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-05-15 (Počet položiek: 2 898 636)
© Copyright 2024 NORMSERVIS s.r.o.