Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determination of Total Sulfur in Liquid Hydrocarbons and Hydrocarbon-Oxygenate Blends by Gas Chromatography with Flame Photometric Detection
Automaticky preložený názov:
Štandardná testovacia metóda pre stanovenie celkového obsahu síry v tekutých uhľovodíkov a uhľovodíkov-oxidačné činidlo Zmesi plynovou chromatografiou s Flame fotometrickej detekcie
NORMA vydaná dňa 1.4.2016
Označenie normy: ASTM D7041-16
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2016
Kód tovaru: NS-636020
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
flame photometric detector, gas chromatography, total sulfur,, ICS Number Code 75.160.20 (Liquid fuels)
Significance and Use | ||||||||||
4.1 This test method can be used to determine total sulfur levels in process feeds and finished products that fall within the scope of this test method. 4.2 Low levels of sulfur in process feed stocks can poison expensive catalysts used in petroleum refining processes. This test method can be used to monitor sulfur levels in these feedstocks. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the determination of total sulfur in liquid hydrocarbons with a final boiling point less than 450 °C by gas chromatography using a flame photometric detector. 1.2 This test method is applicable for total sulfur levels from 0.5 mg S/kg to 100 mg S/kg. Note 1: The pooled limit of quantification (PLOQ) derived from
the 2002 interlaboratory cooperative test program was determined to
be 1 mgS/kg.
Note 2: Samples can also be tested at other total sulfur
levels, but the precision statements may not apply.
1.3 The values stated in SI units are to be regarded as standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7. |
||||||||||
2. Referenced Documents | ||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-05-13 (Počet položiek: 2 898 634)
© Copyright 2024 NORMSERVIS s.r.o.