Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D4580/D4580M-12(2018)
Standard Practice for Measuring Delaminations in Concrete Bridge Decks by Sounding
NORMA vydaná dňa 1.4.2018
Informácie o norme:
Označenie normy: ASTM D4580/D4580M-12(2018)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2018
Kód tovaru: NS-818530
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D4580/D4580M-12(2018) :
Keywords:
concrete bridge deck, delamination, sounding,, ICS Number Code 93.040 (Bridge construction)
Doplňujúce informácie
| Significance and Use |
|
2.1 This practice may be used in conjunction with other methods in determining the general condition of concrete bridge decks. 2.2 This practice may be used in determining specific areas of delamination requiring repair. |
| 1. Scope |
|
1.1 This practice covers procedures for surveying concrete bridge decks by sounding to determine delaminations in the concrete. It is not intended that the procedures described herein are to be used on bridge decks that have been overlaid with bituminous mixtures. The procedures may be used on bridge decks that have been overlaid with portland cement concrete mixtures; however, areas indicated to be delaminated may have a lack of bond between the overlay and the underlying bridge deck (Note 1). Note 1: The influence of variable field conditions such as
traffic noise, vibration, moisture content of the concrete, and the
like, are not completely known and additional investigation may be
needed. It is generally agreed that the practice should not be used
on frozen concrete.
1.2 The following three procedures are covered in this practice: 1.2.1 Procedure A, Electro-Mechanical Sounding Device—This procedure uses an electric-powered tapping device, sonic receiver, and recorder mounted on a cart. The cart is pushed across the bridge deck and delaminations are recorded on the recorder. 1.2.2 Procedure B, Chain Drag—This procedure consists of dragging a chain over the bridge deck surface. The detection of delaminations is accomplished by the operator noting dull or hollow sounds. Tapping the bridge deck surface with a steel rod or hammer may be substituted for the chain drag. 1.2.3 Procedure C, Rotary Percussion2—This procedure consists of rolling a dual-wheel, multi-toothed apparatus attached to an extension pole over the bridge deck surface. The percussive force caused by the tapping wheels will create either a dull or hollow sound, indicating any delamination. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Doporučujeme:
