Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM C330/C330M-17a
Standard Specification for Lightweight Aggregates for Structural Concrete (Includes all amendments And changes 7/31/2023).
NORMA vydaná dňa 15.6.2017
Informácie o norme:
Označenie normy: ASTM C330/C330M-17a
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.6.2017
Kód tovaru: NS-688011
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM C330/C330M-17a :
Keywords:
ICS Number Code 91.100.30 (Concrete and concrete products)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers lightweight aggregates intended for use in structural concrete in which prime considerations are reducing the density while maintaining the compressive strength of the concrete. Procedures covered in this specification are not intended for job control of concrete. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.2.1 With regard to other units of measure, the values stated in inch-pound units are to be regarded as standard. 1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. Note 1: This specification is regarded as adequate to ensure
satisfactory lightweight aggregates for most concrete. It is
recognized that it may be either more or less restrictive than
needed for some conditions and for special purposes, such as fire
resistance, fill, and concrete constructions, the use of which is
based on load tests rather than conventional design
procedures.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
