Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM B911/B911M-12(2016)
Standard Specification for ACSR Twisted Pair Conductor (ACSR/TP)
NORMA vydaná dňa 1.10.2016
Informácie o norme:
Označenie normy: ASTM B911/B911M-12(2016)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2016
Kód tovaru: NS-665986
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM B911/B911M-12(2016) :
Keywords:
aeolian vibration, aluminum, aluminum conductor, ASCR, electrical conductors, galloping, overhead conductors, steel-reinforced conductors, stranded aluminum conductors, TP, twisted pair,, ICS Number Code 33.120.20 (Wires and symmetrical cables)
Doplňujúce informácie
| 1. Scope | ||
|
1.1 This specification covers ACSR Twisted Pair Conductor (ACSR/TP) for use as overhead electric conductors (see Notes 1 and 2). Note 1: The conductor is fabricated from two component ACSR
conductors of the same size twisted helically around each other.
This conductor is identified by the code name of the component ACSR
conductor followed by /TP or the size and type of the component
ACSR conductor followed by /TP.
Note 2: There are registered trademark symbols that are also
used to identify the twisted pair notation. Consult cable
manufacturers for additional details.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.2.1 For conductor sizes designated by AWG or kcmil, the requirements in SI units have been numerically converted from corresponding values stated or derived in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units. For density, resistivity, and temperature, the values stated in SI units are to be regarded as standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
| 2. Referenced Documents | ||
|
Doporučujeme:
