Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A592/A592M-10(2015)
Standard Specification for High-Strength Quenched and Tempered Low-Alloy Steel Forged Parts for Pressure Vessels
Automaticky preložený názov:
Štandardné špecifikácie pre vysoko pevnostné zušľachtené nízkolegované výkovky pre tlakové nádoby
NORMA vydaná dňa 1.3.2015
Informácie o norme:
Označenie normy: ASTM A592/A592M-10(2015)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.3.2015
Kód tovaru: NS-581495
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM A592/A592M-10(2015) :
Keywords:
high-strength low-alloy steel, pressure vessel service, quenched and tempered steel, steel forgings&mdash,alloy,, ICS Number Code 23.060.01 (Valves in general)
Doplňujúce informácie
| 1. Scope | ||||||||
|
1.1 This specification2 covers high-strength quenched and tempered low-alloy steel forged parts for pressure vessels. The maximum thickness of forgings under this specification shall be 11/2 in. [38 mm] for Grade A, and 4 in. [100 mm] for Grades E and F. Note 1: These grades are similar to corresponding grades in
Specification A517/A517M.
1.2 Although no provision is made for supplementary requirements in this standard, the supplementary requirements in Specification A788/A788M may be considered by the purchaser. 1.3 Welding technique is of fundamental importance and it is presupposed that welding procedures will be in accordance with approved methods for the class of material used. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units. |
||||||||
| 2. Referenced Documents | ||||||||
|
Doporučujeme:
